 |
|||||||||||||||||||
|
|||||||||||||||||||
Paint right over USA Fluid Unlimited
StrongArm
It's a Simple 1, 2, 3 Then
Paint it Process as shown right here... |
|||||||||||||||||||
 |
|||||||||||||||||||
| 1) We Take the hunk of
rusty iron and Apply USA Fluid the Unlimited StrongArm. It can be brushed over the surface from the nipple dispenser bottle and a small 1 or 2 inch paint brush. 100% of the USA Fluid goes on the surface with no loss. The other products have a hair spray nozzles
that make a mist which loses nearly all of it into the air as
pollution. |
|||||||||||||||||||
 |
|||||||||||||||||||
| 2) Brush
the surface of the metal with a wire brush for up to a half
minute. |
|||||||||||||||||||
 |
|||||||||||||||||||
| 3) Wipe the surface with
an old cotton cloth, towel or rag. The surface is now undercoated and READY FOR PAINT with a weatherproof bulletproofing that will remain Under the Paint !! You can't do this with anything else !!. Remember: DO
NOT remove the USA Fluid The Unlimited StrongArm
with any paint removers thinners and cleaners. That is NOT
necessary and a waste of material and expense. |
|||||||||||||||||||
 |
|||||||||||||||||||
| Lightly Apply Enamel or
Lacquer paint by spray or brush and let it stand. Allow time for
drying. Then put the piece out in the sun or warm area to cure
paint. With the USA Fluid the paint will have superior adhesion
and carry the paint into the surface deep below the paint. The
painted surface will not rust anymore, even if the paint is
scratched away in use..
It's That simple. |
|||||||||||||||||||
